top of page

Product Application & Care

DTF Pressing Instructions

Heat press with adjustable pressure recommended.

Pre-heat press to 270F. 

You may need to adjust you temperature up or down depending on your press.

You will want HEAVY pressure.

Press your garment to release trapped moisture & smooth out creases.


You can also fold your garment in half and press to find the center.

Figure out your placement and lay the transfer on the garment.

You can use heat tape to secure your print before pressing.

*Use the placement guide below as a reference*

Press with only the transfer sheet for 10-12 seconds.

Release your press.

 

These are HOT PEEL transfers.

Go slow if it is your first time using these transfers.

You may need to adjust your heat/time/pressure settings if they are not sticking.

Press for a second time with a Teflon sheet covering the design.

You should be able to see the weave of the fabric imprinted into the design if pressed correctly.

740e4fc90ce004ef0d0ca694ac87ed82.jpg

Placement Suggestions & Tips

You may want to use t-shirt rulers to get a good space between the collar of your shirt and your design.


I use these, but remove them from the garment before pressing.

(I've left them on my press before, thankfully they didn't melt.)

UV DTF Application

No heat press needed. Hard, smooth surfaces work best.

Clean your surface.

Rubbing alcohol with a lint-free cloth is best.

Rub an old gift card or plastic squeegee over the whole decal to ensure that it is stuck to the transfer sheet.
 

Figure out your placement.

The decals are EXTREMELY sticky and once they touch the surface they will not come off.

Peel the backing away from the design.

Place your design & rub it over the top again to make sure it's stuck. 

Peel the transfer sheet up, leaving behind the design.

 

If placing on drinkware, handwash is recommended.

Vinyl Decal Application

No heat press needed. Hard, smooth surfaces work best.

Clean your surface.

Rubbing alcohol with a lint-free cloth is best.

Rub an old gift card or plastic squeegee over the whole decal to ensure that it is stuck to the transfer sheet.
 

Figure out your placement.

The decals are EXTREMELY sticky and once they touch the surface they will be difficult to reposition..

Peel the backing away from the design.

If it is a large design, you may want to do this in sections as shown here.

Place your design & rub it over the top again to make sure it's stuck. 

Peel the transfer sheet up, leaving behind the design.

 

If placing on drinkware, handwash is recommended.

Sublimation Pressing Instructions

Heat Press Recommended, Light colored polyester required.

Pre-heat press to 400F. 
 

Press your garment to release trapped moisture & smooth out creases.

Lint roll the entire garment. Lint & other debris will cause PERMANENT ink spots. 

Figure out your placement.
Fold the garment and the transfer in half to find the center.

*Use the placement guide below as a reference*

Place blowout paper inside the garment. Use a fresh sheet every time. 

You will also need a sheet to go on top of the transfer paper. 

Place blowout paper on top of the design. You may also want to use heat-resistant tape to secure your design. Any movement can cause ghosting.

Press for 60 seconds.


 

Peel up the transfer sheet right after pressing.

Do not slide the image, lift it straight up to avoid ghosting.

Do not press a second time. 

CONTACT SUPPORT

How Can We Help?

Thanks for submitting!

bottom of page